Extron-electronics AVTrac (482) User Guide Manual do Utilizador descarregar pdf (Página 17)

7. Lay the base track on the ﬂoor in the

prepared location.

Mate the tabs in the side ramps with the

grooves in the base track, and place the end

ramps in position at the end of the track

furthest from the wall.

8. Using the provided masonry bit, drill

5/32 inch diameter by 1 1/2 inch deep

pilot holes into the concrete through the

predrilled mounting holes in the track and

ramps.

9. Secure the track and ramps to the ﬂoor

with the provided masonry screws.

NOTE: Do not use the holes that were

drilled to secure the connectivity

box in sub-step 6 of this section.

Tab on side ramp

mates with groove

in base track.

Side Ramp

Base Tr ack

Drill a 5/32” x 1 1/2” deep hole

into concrete.

Supplied Masonry Screws

AVTrac • Installation 11

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 27 28

Sem comentários

Extron-electronics AVTrac (482) User Guide Manual do Utilizador Página 17