Extron-electronics IPL T Series Setup Guide Manual do Utilizador

Setup Guide68-1377-01 Rev. E09 10IPL T SeriesIP Link Ethernet Control InterfacesIP Link®(IPL T S Series, IPL T SFI244, IPL T CR48)IMPORTANT:Refer to w

4 IPL T Series • IntroductionIPL T SFI244Features of the IPL T SFI244 include: 12 VDC, 1 A desktop power supply RJ-45 Ethernet receptacle Two (2

5IPL T Series • IntroductionBlindsLANPOWER12V 0.5AINPUT21 3 4 56781234ExtronIPL T CR48Ethernet ControlInterfaceProjectorLighting SystemScreenC

6 IPL T Series • IntroductionFigure 4. Global Configurator Application ScreenUsing GC you can configure a single room controller or create a Web-based

7IPL T Series • IntroductionSystem RequirementsThe miminum system requirements for the PC on which you install Global Configurator include: Intel® Pe

8 IPL T Series • IntroductionTo install Global Configurator from an Extron Software Products Disk if Autorun is not enabled on your PC:1. Insert the E

IPL T Series • Setup 9SetupThis section describes the hardware setup and configuration of the IPL T Series controllers. Topics that are covered include

10 IPL T Series • Setupe LINK LED — A green LED lights to indicate that the unit is connected to an active network.f ACT LED — A yellow LED lights t

11IPL T Series • SetupIPL T CR484231RELAY8675IPL T CR48R4231INPUT100LINKACT7613245a Power LED — A green LED lights to indicate that the unit is recei

12 IPL T Series • SetupIPL T SFI244COM1 COM2LANPOWER12V .5A MAXFLEX I/O21 3 4 1IR2 3 4TX RXTX RXGSGSGSGSMAC: 00-05-A6-XX-XX-XXS/N:IPL T SFI244

13IPL T Series • SetupResetting the ControllerThere are five reset modes (numbered 1, 2, 3, 4, 5 for the sake of comparison with other Extron IPL produ

Safety PrecautionsThis symbol is intended to alert the user of important operating and maintenance (servicing) instructions in the literature provided

14 IPL T Series • SetupConnections and WiringPower ConnectionTo connect the power supply:1. Insert the 2-pole captive screw connector into the power

15IPL T Series • SetupA cable that is wired as T568A at one endand T568B at the other (Tx and Rx pairsreversed) is a "crossover" cable.A cab

16 IPL T Series • SetupCaptive screw connectorThe IPL T S2, IPL T S6, and IPL T SFI244 have COM ports with captive screw connectors. The two COM ports

17IPL T Series • SetupIR PortsThe IPL T SFI244 has four IR ports for infrared device connection. You can connect IR emitters or a wired IR control por

18 IPL T Series • SetupFlex I/O PortsThe IPL T SFI244 has four Flex I/O ports that can be configured as digital inputs, digital outputs, or analog inpu

19IPL T Series • SetupThen, you must change the default settings of the controller (IP address, subnet mask, and [optional] administrator name and pas

20 IPL T Series • Setup5. Execute a ping command by typing ping followed by a space and the new IP address at the command prompt. For example:ping 10

21IPL T Series • Setup

USA, Canada, South America, and Central America: Extron USA 1001 East Ball Road Anaheim, CA 92805 U.S.A.Europe, Africa, and the Middle East: Extron Eu

Extron USA - WestHeadquarters+800.633.9876Inside USA/Canada Only+1.714.491.1500+1.714.491.1517 FAXExtron USA - East+800.633.9876Inside USA/Canada Only

FCC Class A NoticeThis equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rule

IPL T Series • Contents vContentsIntroduction ...1About this Guide ...1IPL T Series P

IPL T Series • Contentsvi

IPL T Series • Introduction 1IntroductionThis section gives an overview of the setup guide and describes the IPL T Series IP Link® Ethernet Control In

2 IPL T Series • IntroductionIPL T S2Features of the IPL T S2 include: 12 VDC, 1 A desktop power supply RJ-45 Ethernet receptacle Two (2) 9-pin

3IPL T Series • IntroductionCOM 3LANUID# 093012052POWER12V .5A MAXCOM 2COM 1COM 2LightingControlEthernetRS-232RS-232DVDLaptopVCRRemote UserCon