Extron-electronics LANCIAxi User Guide Manual do Utilizador descarregar pdf (Página 12)

Extron • SENTOSA

LQ & LANCIA

LD • User’s Manual

Installation and Operation

Page 2-1

Installing the Sentosa

xixi

xi/Lancia

xixi

If rack mounting is required it should be done before cabling,

otherwise, skip to “Cabling” below.

Rack Mounting

The Sentosaxi/Lanciaxi can be rack mounted using one side of an

optional 19” 1U Universal Rack Shelf (Extron PN# 60-190-01).

To rack mount the Sentosaxi/Lanciaxi, do the following:

1. If feet were previously installed on the bottom of the case,

remove them.

2. Mount the Sentosaxi/Lanciaxi on the rack shelf as shown

below using two 4-40 x 1/8 screws in opposite (diagonal)

corners to secure the case to the shelf.

3. Upon completion of the rack mounting procedure, go to

“Cabling” below.

Cabling

The Sentosaxi/Lanciaxi is capable of switching between two

inputs, one composite and one S-Video. Therefore, one of each

video input type may be connected.

Connecting the Input/Output Cables

1. Connect the input devices to the Sentosaxi/Lanciaxi using the

appropriate cables as described below. Use the diagram on the

next page as a general guide.

A. If the input device to be connected has an S-Video output,

an S-Video cable will be used to connect it to the S-Video

input connector of the Sentosaxi/Lanciaxi.

B. If the input device to be connected has a composite video

output, a BNC cable will be used to connect it to the BNC

input of the Sentosaxi/Lanciaxi. The composite video output

from a VCR or Laser Disc Player will most likely require an

RCA to BNC adapter. An adapter of this type can generally

be purchased at a local electronics store.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 27 28

Sem comentários

Extron-electronics LANCIAxi User Guide Manual do Utilizador Página 12