Extron-electronics MLM-WB+ User Guide Manual do Utilizador descarregar pdf (Página 13)

2-7MLM-WB • Installation

5. For each slotted mounting hole ( ) for which you have drilled a pilot hole:

a. Insert a provided masonry screw through a flat metal washer (1”, 2.5 cm

outer diameter; 0.25”, 0.6 cm inner diameter).

b. Insert the screw into the pilot hole.

c. Securely fasten each screw (or toggle bolt) into the wall until a gap of

1/8” (3 mm) remains between the wall and the metal washer.

6. Align the slotted mounting holes in the back of the MLM-WB’s outer

enclosure with the screws and/or toggle

bolts in the wall. Move the MLM-WB

forward over the washers and down as

shown in the illustration at left.

Hanging the outer enclosure on the screws/bolts

7. For each smaller, round mounting hole (in the middle row of holes) for which

you have drilled a pilot hole:

a. Insert a provided masonry screw through a flat metal washer (1”, 2.5 cm

outer diameter; 0.25”, 0.6 cm inner diameter).

b. Insert each screw into the pilot hole.

8. For all the screws (inserted through slotted holes or round holes), firmly

tighten the screws and/or toggle bolts to secure the MLM-WB to the wall.

Installing the MLM-WB on a non-masonry wall

On non-masonry walls the MLM-WB must be attached to at least one stud.

1. Select a location with adequate clearance for the MLM-WB’s enclosure and for

the open door, the extended shelf, and video tape insertion and removal.

2. Locate the wall studs in the area where you will install the MLM-WB, and use

a pencil to mark the studs’ locations on the wall.

3. Hold the MLM-WB’s outer enclosure against the wall, and use a level tool as a

guide for leveling the enclosure. (Lay the level on the top of or on the floor of

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 33 34

Sem comentários

Extron-electronics MLM-WB+ User Guide Manual do Utilizador Página 13