Extron-electronics PIP 444 User Guide Manual do Utilizador descarregar pdf (Página 11)

2-3PIP 422 and PIP 444 Picture-in-Picture Processors • Installation

#8 Screw

(4 Plcs)

Each Side

Optional Furniture Mounting Bracket

Supplied Rack Mounting Bracket

Mounting Screws

(2 Plcs)

Each Side

Figure 2-1 — Mounting a PIP

3. Insert the processor into the rack, align the holes in the mounting bracket with

those of the rack.

4. Secure the processor to the rack using the supplied machine screws.

Table or wall mounting

The table/wall mounting brackets extend approximately 1/4" (6.4 mm) above the

top surface of the processor enclosure. This design allows for an air space between

the enclosure and the surface to which it is mounted. Table or wall mount the

PIP as follows:

1. Remove the feet from the underside of the PIP, if installed.

2. Attach the table/wall mounting brackets to the processor with the eight

provided #8 machine screws (figure 2-1).

3. Hold the processor with the attached brackets against the underside of the

table or other furniture, or against the wall. Mark the location of the screw

holes of the bracket on the mounting surface.

4. Drill 3/32" (2 mm) diameter pilot holes, 1/4" (6.4 mm) deep in the mounting

surface at the marked screw locations.

5. Insert #8 wood screws into the four pilot holes. Tighten each screw into the

mounting surface until just less than 1/4" (6 mm) of the screw’s head

protrudes.

6. Align the mounting screws with the slots in the brackets and place the

processor against the surface, with the screws through the bracket slots.

7. Slide the PIP slightly forward or back, then tighten all four screws to secure

the processor in place.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 61 62

Sem comentários

Extron-electronics PIP 444 User Guide Manual do Utilizador Página 11