Extron-electronics SMD 101 User Guide Manual do Utilizador Página 18

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
  • Página
    / 105
  • Índice
  • MARCADORES
  • Avaliado. / 5. Com base em avaliações de clientes
Vista de página 17
SMD101 Rear Panel Reset
The Reset button on the rear panel of the SMD101 (see Figure 3 on page9) returns the
SMD101 to various modes of operation.
To select different reset modes, use a pointed stylus or small screwdriver to press and hold
the Reset button while the SMD101 is powered, or press and hold the Reset button while
applying power to the SMD101.
ATTENTION: Review the reset modes carefully. Some reset modes delete all
user loaded content and revert the device to default configuration. The SMD101
Reset Summary on page83 provides a summary of the reset modes and the
configuration settings affected by each mode.
NOTES:
The reset modes close all open IP and Telnet connections and all sockets.
Each reset mode is a separate reset (not a continuation from mode 1 to mode 5).
Reset modes 2 and 3 are not available for the SMD101.
The SMD101 can also be reset using the web-based user interface (see Reset
Device on page42).
For information on resetting the SMD101 using SIS commands, see Resets on
page68 of the Command and Response Tables section.
Further details comparing the reset modes and affected configuration settings
and user content are in the reference section (see SMD101 Reset Summary on
page83).
RESET
RESET
RESET RESET
RESET
Release, then immediately
press and release again. Reset
LED flashes, then goes off.
Modes 4 and
5
Press and hold
the Reset button.
Mode 1
Reset LED flashes
twice or three times.
Press and
hold for
6 or 9 seconds
.
Apply power
to the SMD 101.
Release Reset button.
Figure 9. Resetting the SMD101
SMD101 • Panels and Cabling 12
Vista de página 17
1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 104 105

Comentários a estes Manuais

Sem comentários