Extron-electronics FOX II T_R DP User Guide Manual do Utilizador Página 1

User GuideFOX II T DPFOX II R DPFiber Optic ExtendersFiber Optic Transmitter and Receiver for DisplayPort68-1988-01 Rev. A02 14

FOX II DP Transmitter and Receiver • Introduction4FeaturesUltra high performance — Offers pixel-for-pixel DisplayPort video transmission, up to 2560x

FOX II DP Transmitter and Receiver • Introduction5Simple Instruction Set — The transmitter and receiver use the SIS for easy remote control operation

FOX II DP Transmitter and Receiver • Installation and Operation6Installation and OperationThis section details the installation of the FOX II DP trans

FOX II DP Transmitter and Receiver • Installation and Operation7c Analog audio input ports — These connectors accept the analog, LRAUDIO unamplifie

FOX II DP Transmitter and Receiver • Installation and Operation8h Fiber optic ports and LEDs —WARNING: Potential vision damage — These units output

FOX II DP Transmitter and Receiver • Installation and Operation9Front panel1 2CONFIGFOX II T DPSELECTHDCPSIGNALRETURN OUTINPUTVIDEO AUDIO EDID1011Fig

FOX II DP Transmitter and Receiver • Installation and Operation10Receiver ConnectionsRear panelFOX II R DPDISPLAYPORTRS-232RS-232IRALARMTx Rx Tx Rx

FOX II DP Transmitter and Receiver • Installation and Operation11n Audio output ports — These connectors output the transmitted, LRAUDIO unamplifie

FOX II DP Transmitter and Receiver • Installation and Operation12Front panel1 2CONFIGHDCPSIGNALRETURN OUTINPUTVIDEO AUDIOFOX II R DP20Figure 5. FOX

FOX II DP Transmitter and Receiver • Installation and Operation13Audio connectionsNOTE: The level of the analog audio inputs can be set via an SIS c

Safety InstructionsSafety Instructions • EnglishWARNING: This symbol, , when used on the product, is intended to alert the user of the presence of u

FOX II DP Transmitter and Receiver • Installation and Operation14Audio output connectorSee figure 9, below, to properly wire a captive screw output c

FOX II DP Transmitter and Receiver • Installation and Operation15Power supply wiringATTENTION: Always use power supplies specified by Extron for the

FOX II DP Transmitter and Receiver • Installation and Operation16Indications and OperationTransmitter IndicationsHDCPSIGNALRETURN OUTINPUTCONFIGVIDEO

FOX II DP Transmitter and Receiver • Installation and Operation17OperationAfter the transmitter, all receivers, and their connected devices are power

FOX II DP Transmitter and Receiver • Remote Control18Remote ControlThis section describes the remote control operation of the FOX II DP transmitter an

FOX II DP Transmitter and Receiver • Remote Control19Unit-initiated MessagesWhen a local event, such as an equipment power-up, occurs, the unit respo

FOX II DP Transmitter and Receiver • Remote Control20Using the Command and Response TablesThe command and response table for the transmitter begins o

FOX II DP Transmitter and Receiver • Remote Control21Command and Response Table for Transmitter SIS CommandsCommand SIS Command (host to unit)Respons

Command/response table for Transmitter SIS commands (continued) FOX II DP Transmitter and Receiver • Remote Control22Command SIS Command (host to uni

Command/response table for Transmitter SIS commands (continued) FOX II DP Transmitter and Receiver • Remote Control23Command SIS Command (host to uni

FCC Class A NoticeThis equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part15 of the FCC rule

FOX II DP Transmitter and Receiver • Remote Control24Symbol Definitions for Receiver SIS Commands] = CR/LF (carriage return/line feed)} = Carriag

Command/response table for Receiver SIS commands (continued) FOX II DP Transmitter and Receiver • Remote Control25Command SIS Command (host to unit)R

Command/response table for Receiver SIS commands (continued) FOX II DP Transmitter and Receiver • Remote Control26Command SIS Command (host to unit)R

FOX II DP Transmitter and Receiver • Remote Control27Product Configuration SoftwareThe Extron Product Configuration Software, which communicates with

FOX II DP Transmitter and Receiver • Remote Control284. Enter the requested personal information;TIP: Click Remember Me to eliminate step 4 in futur

FOX II DP Transmitter and Receiver • Remote Control292. If this is the first use with the FOX II units, click the New tab. The program opens to the

FOX II DP Transmitter and Receiver • Remote Control30 15236784Figure 17. Status Window for the ReceiverUsing the SoftwareOnce you have connected to

FOX II DP Transmitter and Receiver • Remote Control31h HDCP Signal indicator — Shows a lock icon ( ) when the digital video signal has a copyright e

FOX II DP Transmitter and Receiver • Remote Control32Configuration > EDID Minder screen (transmitter connection only)The EDID Minder screen (see f

FOX II DP Transmitter and Receiver • Remote Control33Configuration > Input/Output Configuration screenThe Input/Output Configuration screen allows

FOX II DP Transmitter and Receiver • IntroductionivConventions Used in this GuideNotifications The following notifications are used in this guide:WAR

FOX II DP Transmitter and Receiver • Remote Control34c Video Mute button — Click this button to toggle the video mute on and off for the transmitt

FOX II DP Transmitter and Receiver • Remote Control35Receiver Input/Output Configuration screen1234567Figure 20. Input/Output Configuration Screen f

FOX II DP Transmitter and Receiver • Remote Control36e Tx Output radio buttons — Select among the available radio buttons to define the function o

FOX II DP Transmitter and Receiver • Remote Control37Hardware > Device Name screen (both units) The Device Name screen provides controls to allow

FOX II DP Transmitter and Receiver • Remote Control38 Folder WhereFirmware isInstalled.4232Figure 22. Downloading Firmware Upgrade Files

FOX II DP Transmitter and Receiver • Remote Control396. Start the Product Configuration Software and connect to the unit (see Starting the Program,

FOX II DP Transmitter and Receiver • Remote Control4011. Click Update.The software advises you that you are about to reprogram the unit firmware. Cli

FOX II DP Transmitter and Receiver • Unit Mounting41Unit MountingMounting the UnitsATTENTION: Installation and service must be performed by authorize

Extron Headquarters+1.800.633.9876 (Inside USA/Canada Only)Extron USA - West Extron USA - East +1.714.491.1500 +1.919.850.1000 +1.714.491.1517 FAX +

vFOX II DP Transmitter and Receiver • ContentsContentsIntroduction... 1About this Guide ...

FOX II DP Transmitter and Receiver • Contentsvi

FOX II DP Transmitter and Receiver • Introduction1IntroductionWARNING: Potential vision damage — The FOX II DP transmitter and receiver output contin

FOX II DP Transmitter and Receiver • Introduction2About the FOX II DP Transmitter and ReceiverThe FOX II DP Transmitter and Receiver are an ultra-hig

FOX II DP Transmitter and Receiver • Introduction3System CompatibilityThe FOX II T DP transmitter is compatible with all Extron FOX II receivers only