Extron-electronics FOX II T_R DP User Guide Manual do Utilizador descarregar pdf (Página 15)

FOX II DP Transmitter and Receiver • Installation and Operation

Front panel

1 2

CONFIG

FOX II T DP

SELECT

HDCP

SIGNAL

RETURN OUT

INPUT

VIDEO AUDIO EDID

1011

Figure 3. FOX II DP Transmitter Front Panel Control and Connector

j EDID Select rotary switch — Set this switch to one of the positions below

SELECT

EDID

to select the source of the DDC or a specific resolution.

Position 0 — A user-recorded EDID that has been:

• Captured from the display connected to the receiver output.

• Captured from the display connected to transmitter DisplayPort Loop-through

connector (see item

on figure 2 on page 6).

• Manually imported via an SIS command (see page 21) or Product Configuration

Software action (see page 32) to the transmitter.

Position 1 — The EDID is selected via the rear panel Remote RS-232 port or the front

panel Configuration port, using an SIS command or the Product Configuration Software.

This is the factory default position.

Position 2 — The EDID is received from the display connected to the receiver.

Position 3 — The EDID is received from the display connected to the DisplayPort

Loop-through connector (see item

on figure 2 on page 6).

Position 4 – F — Specify a resolution. The table below identifies the switch positions

and the associated resolutions. All resolutions are at 60 Hz.

Pos. Source or resolution Pos. Resolution Pos. Resolution

0 User recorded EDID 6 1280x800 C 1920x1080 (1080p)

1 Selected via RS-232 7 1366x768 D 1920x1200

2 Display on Rx output 8 1400x1050 E 2048x1536

3 Display on Tx loop-through 9 1440x900 F 2560x1600

4 1024x768 A 1600x1200

5 1280x720 (720p) B 1680x1050

k Configuration port — Connect a controlling device, such as a PC, to this

CONFIG

mini USB B port for control of all FOX II T DP functions and to install a firmware

upgrade (see Remote Control on page 18 for SIS commands and software

control).

This port serves a similar communications function as the rear panel Remote RS-232

port (see item

on page 7), but it is easier to access than the rear port after the

transmitter has been installed and cabled.

NOTE: A front panel Configuration port connection and a rear panel Remote

RS-232 port connection can both be active at the same time. If commands are

sent simultaneously to both, the command that reaches the processor first is

handled first.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 47 48

Comentários a estes Manuais

Sem comentários

Extron-electronics FOX II T_R DP User Guide Manual do Utilizador Página 15

Comentários a estes Manuais

Manuais e produtos relacionados com Acessórios para vídeo Extron-electronics FOX II T_R DP User Guide