Extron-electronics Cable Retraction System User Guide Manual do Utilizador descarregar pdf (Página 21)

Cable Retraction System • Installation 15

Horizontal Bracket Mounting

For horizontal mounting, the horizontal mounting bracket (part number 70-678-00) must be

used. The slotted holes in the mounting bracket allow for tolerance in placing the bracket.

To ensure accurate bracket location, follow these procedures:

1. Attach the horizontal mounting bracket to the retractor end caps using the provided bolt

and nut.

TIP: Hand tighten the nut only enough to keep the bracket from easily moving.

The bolt and nut will be removed later.

Horizontal Bracket

Mounting Holes

Horizontal Mounting

Bolt

End Caps

Slotted Hole

Figure 14. Attach Horizontal Bracket to End Caps

2. Raise the retraction system with attached bracket to the desired mounting location.

NOTE: Be certain the system is perpendicular to the enclosure to prevent

binding of the pulley system.

Top View

Horizontal

Bracket

UNSWITCHED

100-240V/ 5AMAX

UNSWITCHED

USP HUB4 AAP

ACTIVITY

100-240V/ 5AMAX

CC800

Figure 15. Align Retraction System Perpendicular to Cable Cubby Enclosure

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 35 36

Sem comentários

Extron-electronics Cable Retraction System User Guide Manual do Utilizador Página 21