Extron-electronics PVS 305SA User Guide Manual do Utilizador

PVS 305SAPoleVault® Switcher68-1576-01 Rev. A02 10

PVS 305SAPVS 305SA2Chapter TwoInstallationUL/Safety RequirementsMounting the SwitcherRear Panel Features and CablingSpeaker ConfigurationLabeling the A

PVS 305SA Switcher • Installation2-2InstallationPRELIMINARYUL/Safety RequirementsThe Underwriters Laboratories (UL) requirements listed below pertain

2-3PVS 305SA Switcher • Installation PRELIMINARYMounting the SwitcherThe PVS 305SA switcher and the power supply can be mounted in the Extron PMK 550

PVS 305SA Switcher • Installation2-4InstallationPRELIMINARYMounting onto the plate using brackets.N This method allows mounting and removal of the Po

2-5PVS 305SA Switcher • Installation PRELIMINARYWall mounting the PoleVault switcherUsing the Extron WMK 100 Wall Mounting Kit, the PoleVault switcher

PVS 305SA Switcher • Installation2-6InstallationPRELIMINARYRear Panel Features and Cabling L RL RL RAUX AUDIOINPUT 5LINE OUTVOICELIFTRECEIVERPAGINGSEN

2-7PVS 305SA Switcher • Installation When connecting the TP cables to the PVS 305SA, take care not to cross-connect the cables; connect input cable 1A

Installation, cont’dPVS 305SA Switcher • Installation2-8PRELIMINARYA/V output connectionsc RGB video output — Connect a VGA cable to this female 15-p

2-9PVS 305SA Switcher • Installation Switcher controli Control port — The PVS switcher can be controlled via an RS -232 connection directly from a ho

Installation, cont’dPVS 305SA Switcher • Installation2-10PRELIMINARYPVS 305SA Rear PanelL RL RL RAUX AUDIOINPUT 5LINE OUTVOICELIFTRECEIVERPAGINGSENSOR

This symbol is intended to alert the user of important operating and maintenance (servicing) instructions in the literature provided with the equipmen

2-11PVS 305SA Switcher • Installation Speaker outputj Amplified audio out — Connect one speaker to each channel marked “L” and “R” (left and right) us

Installation, cont’dPVS 305SA Switcher • Installation2-12PRELIMINARYLabeling the A/V InputsLabeling and connecting the A/V input cablesThe RGB and com

2-13PVS 305SA Switcher • Installation Labeling the PVT Decora face platesTo help identify the input number and type of signal that any PVT Decora wall

PVS 305SA3Chapter ThreeOperation and SetupFront Panel Features and Operation Setting Switcher ModesAuto SwitchingSetting Up and Optimizing the AudioRe

PVS 305SA Switcher • Operation and Setup3-2Operation and SetupPRELIMINARYFront Panel Features and Operation PVS 305SAPOLEVAULT SWITCHERINPUT SELECTION

3-3PVS 305SA Switcher • Operation and Setup PRELIMINARYFront panel operationN See the front panel image (figure 3-1) for the location of input buttons

Operation and Setup, cont’dPVS 305SA Switcher • Operation and Setup3-4PRELIMINARYExecutive Mode (Front Panel Security Lockout)To prevent accidental or

3-5PVS 305SA Switcher • Operation and Setup PRELIMINARY6. When adjustments to all five inputs’ sensitivity settings have been made, then adjust the am

Operation and Setup, cont’dPVS 305SA Switcher • Operation and Setup3-6PRELIMINARYAmplifier level control Amplifier level control is adjusted via RS-232

PVS 305SA4Chapter FourSerial CommunicationRS-232 Programmer’s GuideUpdating Firmware

FCC Class B NoticeThis equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rule

PVS 305SA • Serial Communication4-2Serial CommunicationPRELIMINARYPRELIMINARYThe PVS 305SA switcher can be remotely set up and controlled via a host c

4-3PVS 305SA • Serial Communication PRELIMINARYPRELIMINARYError responsesWhen the PVS switcher receives a valid SIS command, it executes the command a

Serial Communication, cont’dPVS 305SA • Serial Communication4-4PRELIMINARYPRELIMINARYX# = Status, 0 = off/disable (default) 1 = on/enable = Signal

4-5PVS 305SA • Serial CommunicationPRELIMINARYPRELIMINARYX2# = Video type (inputs 3 and 4 only)1 = Composite video (default) 2 = RGBX2$ = Video sign

Serial Communication, cont’dPVS 305SA • Serial Communication4-6PRELIMINARYPRELIMINARYCommand ASCII command(host to processor) Response(processor to ho

4-7PVS 305SA • Serial CommunicationPRELIMINARYPRELIMINARYCommand ASCII command(host to processor) Response(processor to host)Additional descriptionSe

Serial Communication, cont’dPVS 305SA • Serial Communication4-8PRELIMINARYPRELIMINARYCommand ASCII command(host to processor) Response(processor to ho

4-9PVS 305SA • Serial CommunicationPRELIMINARYPRELIMINARYN X@ = Status: 1 = dual mono, 2 = stereoX# = Status: 0 = off/disable (default), 1 = on/e

Serial Communication, cont’dPVS 305SA • Serial Communication4-10PRELIMINARYPRELIMINARYUpdating FirmwareIf the need arises, you can update the PVS 305S

4-11PVS 305SA • Serial CommunicationPRELIMINARYPRELIMINARY6. When the Firmware Loader window opens, click File, Open and browse to locate and select

iPVS 305SA Switcher • Table of ContentsTable of ContentsPRELIMINARYPRELIMINARYChapter One • Introduction ...

Serial Communication, cont’dPVS 305SA • Serial Communication4-12PRELIMINARYPRELIMINARY9. Wait until the status bar indicates completion. The note “C

PVS 305SA5Chapter FiveSoftware ConfigurationConfiguring the Switcher

PVS 305SA Switcher • Software Configuration5-2Software ConfigurationConfiguring the Switcher The PVS 305SA PoleVault Switcher can be configured using an E

5-3PVS 305SA Switcher • Software ConfigurationSoftware Configuration, cont’d4. Complete the on-screen form and download the .exe file to the PC.5. Laun

PVS 305SA Switcher • Software Configuration5-4 3. Follow any on-screen instructions, which vary depending on the start option selected.N After select

5-5PVS 305SA Switcher • Software ConfigurationSoftware Configuration, cont’dIf “View Global Configurator Help File” is selected, a new window opens showi

PVS 305SAAAppendix AReference InformationSpecifications Part Numbers, Cables, and Accessories

PVS 305SA Switcher • Reference InformationReference InformationA-2SpecificationsVideoGain ... Unity (as

PVS 305SA Switcher • Reference Information A-3Output level ... 4.5 V to 5.5 Vp-p, unterminatedInput impedance ...

Reference Information, cont’dPVS 305SA Switcher • Reference InformationA-4Amplifier type ... Class DGain/volume adjustment

iiPVS 305SA Switcher • Table of ContentsTable of Contents, cont’dPRELIMINARYPRELIMINARYBass, treble, and loudness control ...

PVS 305SA Switcher • Reference Information A-5Part Numbers, Cables, and AccessoriesIncluded partsIncluded partReplacement part numberPVS 305SA 60-98

PVS 305SABAppendix BSpeaker ConfigurationWiring Information

PVS 305SA Switcher • Appendix BAppendix BB-2Terminating the speaker cableTo terminate the cable, strip the end of the cable 0.2 inch (5 mm) and secure

PVS 305SA Switcher • Appendix B B-3 Wiring InformationSignal cablesThe PVS 305SA is capable of receiving signals from PVT wallplates located up to

Appendix B, cont’dPVS 305SA Switcher • Appendix BB-4L RL RL RAUX AUDIOINPUT 5LINE OUTVOICELIFTRECEIVERPAGINGSENSORDO NOTGROUNDOR SHORTSPEAKEROUTPUTS1B

Extron WarrantyExtron® Electronics warrants this product against defects in materials and workmanship for a period of three years from the date of pur

Extron USA - West Headquarters+800.633.9876Inside USA / Canada Only+1.714.491.1500+1.714.491.1517 FAXExtron USA - East+800.633.9876Inside USA / Canada

PVS 305SA1Chapter OneIntroductionAbout this ManualAbout the PVS 305SAApplication Diagram

PVS 305SA Switcher • Introduction1-2IntroductionAbout this ManualThis manual covers the installation, operation, and configuration of the Extron PVS 30

1-3PVS 305SA Switcher • Introduction FeaturesTwisted pair inputs — The PoleVault switcher accepts two independent, high resolution RGB video and audio

Introduction, cont’dPVS 305SA Switcher • Introduction1-4Application DiagramPVS 305SAPOLEVAULT SWITCHERINPUT SELECTION12PEAKNORMALSIGNALCONFIG3 45AUX A