
2-7
SW USB Series • Installation
PRELIMINARY
d
RS-232 Pass Thru port — If desired, connect an Extron A/V switcher to this
3-pole, 3.5 mm connector (see “RS-232 Pass Thru port”, later in this chapter).
Commands issued via the front panel, contact closure, or an RS-232 interface
on a PC or control system can be sent through this port to the connected
switcher.
N
Only Extron products can be controlled via this port.
e
Emulation DIP switches — (SW4 USB Plus only) These DIP switches enable
host emulation to a keyboard and/or mouse connected to output ports 3 and
4. Switch 1 enables host emulation to a mouse; switch 2 enables emulation to
a keyboard.
When a keyboard or a mouse is connected to port 3 or 4, and the appropriate
switch is set to On, the SW USB switches to the connected keyboard or
mouse instantly, without the delay that normally occurs while the computer
recognizes a new peripheral device.
f
Output connectors — Connect peripheral USB devices, such as keyboards
and/or mice, storage drives, or webcams, to these female type A USB
connectors, using cable in lengths of up to 15 feet (4.5 m). All outputs supply
the 500 mA, 5 V rating as dened in USB standards.
N
If your SW USB system contains multiple computers, drivers for all connected
peripheral devices should be loaded on all computers.
N
The four outputs act as a USB hub. Inputs cannot be routed to specific USB
output connectors. All outputs are simultaneously connected to the selected
input.
N
On the SW USB Plus, output ports 3 and 4 can be used for host emulation (with
supported keyboards and mice only). See “Host emulation (SW4 USB Plus
only)” in chapter 3 for more information.
g
Power connector — Attach the provided external 12 VDC power supply
to this two-pole, 3.5 mm captive screw connector (see “Wiring the Power
Connector” in the next section).
Comentários a estes Manuais