Extron electronics TLP 710CV Guia de Configuração descarregar pdf (Página 2)

TLP 710CV • Setup Guide (Continued)

Mounting the TLP 710CV

Step 1 — Obtain Cut-out Dimensions

CAUTIONS: • The table should be cut only by licensed and bonded craftspeople.

 • Makecertainthecorrectcut-outdimensionsarebeingusedbeforeproceedingtothenextstep.Extron

is not responsible for mounting holes that are incorrectly cut.

 • ThesurfacesoftheCableCubbyenclosurehavescrewsandotherprotrudinghardwarethatcould

damage fine furniture. Do not rest the enclosure on unprotected furniture.

 • Ensurethetablesurfaceisatleast0.375inches(0.95cm)thick.

z If using a hand router, you should purchase the Extron TLP 710CV routing template (part number 70-980-01).

z If using a CNC wood router, use the exact cut-out dimensions (see below).

z If using a reciprocating saw or jigsaw use the provided paper cut-out template.

Step 2 — Cut the Surface

WARNING: To avoid eye injury, wear safety glasses when operating power equipment.

Be certain the cut is laid out in exactly the desired location and the edge that opens on the lid is correctly oriented. After

verifying and checking dimensions, cut a hole in the surface of the furniture where the enclosure will be installed (see

“Preparing the Table” in chapter 2 of the TLP 710CV User Guide). There are three methods for cutting the hole in the table:

Hand Router

Recommended — A hand router and the Extron TLP 710CV routing

template, part number 70-980-01. Refer to the Routing Template User

Guide, available at www.extron.com, to prepare the template and use the

template to cut the hole.

NOTE: The metal router guide must be purchased separately. It is

reusable and should not be discarded when the installation is

complete.

CNC Wood Cutter

Recommended — A CNC wood router and the exact cut-out dimensions:

8.90+0.00/-0.02inchesWx7.10+0.00/-0.02inchesD

(22.61+0.00/-0.05 cm Wx18.03+0.00/-0.05cmD)

NOTE: The underlined dimension is the connector or AAP access side

for the unit.

Reciprocating Saw or Jigsaw

Acceptable — A reciprocating saw or jigsaw and the included paper cut-out

template (also available at www.extron.com.)

HSA 200

USER ACCESS

HSA 200

CABLE CUBBY 300

USER ACCESS

Cut-Out Template for the Extron

TLP 710CV

Outer Edge of Trim Ring

(Do not cut this line.)

1. Confirm the product to be installed.

2. Remove the surface cut-out area

(gray) from the template.

3. Mark the position on the wall or

furniture where the TLP 710MV

is being installed.

4. Cut the opening.

P/N 68-2046-01 Rev. B

Page size: 11" x 17"

Print scale 1:1

Do not shrink.

P/N

1 2 3 4 5 6 7 8

Comentários a estes Manuais

Sem comentários

Extron electronics TLP 710CV Guia de Configuração Página 2

Comentários a estes Manuais

Manuais e produtos relacionados com Redes Extron electronics TLP 710CV