5
Product Category
Connecting the TLP 710CV
The cable connections are located in a panel on the bottom of the TLP 710CV:
POWER
12V
1.0A MAX
LAN / PoE MTP
Step 9 — Connect the MTP Input
Connect the output of an Extron Mini Twisted Pair (MTP) transmitter to the MTP socket (
a
) on the TLP 710CV. This signal
provides composite or S-video and audio input.
CAUTION: Connect the MTP transmitter to the MTP socket and the network connector to the network socket. Although
both use RJ-45 connectors, the MTP socket (
a
, on the right) must be connected to an MTP transmitter and
theLAN/PoEsocket(
b
, on the left) must be connected to a LAN. The wires on each connector use different
voltages and inputting the wrong voltages into a socket will damage the TLP 710CV.
Step 10 — Connect the Network and Power Over Ethernet Connector
Extron strongly recommends using a Power over Ethernet (PoE) power supply, although a 12 VDC, 1.0 A power supply (not
provided) can be used instead (see below).
CAUTIONS: • Before connecting the PoE connector (
b
), read the cautions listed in the “Network and Power over
Ethernet Connector” section of the TLP 710CV User Guide, which is available at www.extron.com.
• Connect the network connector to the network socket (
b
) and the MTP transmitter to the MTP socket
(
a
). The wires on each connector use different voltages and inputting the wrong voltages into a socket
will damage the TLP 710CV.
Connecting to the Network Directly (Using an external 12 VDC Power Supply)
If the PoE power supply is not used, connect one end of a straight-through LAN cable, terminated with an RJ-45 connector
intotheLAN/PoEconnection(
b
). Connect the other end into a network switch or router.
Connecting to a Power over Ethernet Power Supply
1. Use a straight-through LAN cable to connect the LAN-IN socket to a
network switch or router.
2. Use a second straight-through LAN cable to connect the PWR LAN-OUT
sockettotheLAN/PoEconnector(
b
) on the TLP 710CV. This cable carries
network information and 48 VDC.
3. Connect the IEC power cord from the power supply to a convenient
100 VAC to 240 VAC, 50-60 Hz power source.
Step 11 — Connect the External Power Supply (Optional)
CAUTION: Before connecting the power supply, read the cautions listed in the “Power Connector” section of the
TLP 710CV User Guide, which is available at www.extron.com.
Extron strongly recommends using PoE to provide power to the TLP 710CV. To use a 12 VDC, 1.0 A power supply (not
provided), connect the two pole, 3.5 mm captive screw connector from the power supply (part number 70-775-01) to the
power supply socket on the rear panel (
c
).
NOTE: For advice about using captive screw connections, see the notes in the “Power Connector” section of the
TLP 710CV User Guide, which is available at www.extron.com.
PWR LAN-OUT LAN-IN
To Network SwitchTo TLP 710CV
Power over Ethernet (PoE) Power Supply
(4 páginas)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentários a estes Manuais