Extron electronics MGP Pro Series Guia do Utilizador descarregar pdf (Página 15)

WindoWall Pro Series • Installation 9

j HDMI inputs (WindoWall Pro DI only) — Connect up to four HDMI input

sources to these HDMI input connectors, as an alternative to using the

fully-configurable BNC input connectors (

l AC power connector — Connect the included power cord from this male

IEC connector to a 100–250 VAC, 50-60 Hz power source.

Front Panel

WindoWall Pro

MULTI-GRAPHIC VIDEOWALL PROCESSOR

Figure 7. WindoWall Pro Front Panel

a Indicator LED — This green LED lights while the WindoWall Pro is receiving power.

Resetting

Resetting the unit causes various IP functions and Ethernet connection settings to revert

to factory defaults. There are four reset modes (numbered 1, 3, 4, and 5 for the sake of

comparison with Extron IP Link products) that are available by pressing the Reset button on

the rear panel. The Reset button is recessed, so you must use a pointed stylus, ballpoint

pen, or small screwdriver to press it (see the Reset Modes Summary table on the next

page for an explanation of all the reset modes).

ATTENTION: Review the reset modes carefully. Using the wrong reset mode may

result in unintended loss of ﬂash memory programming, port reassignment, or

processor reboot.

HDMI

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 89 90

Sem comentários

Extron electronics MGP Pro Series Guia do Utilizador Página 15