Extron electronics MGP Pro Series Guia do Utilizador descarregar pdf (Página 37)

WindoWall Pro Series • Remote Configuration and Control 31

• The WindoWall Pro sends a Reconfig message as each of the four windows is

configured via the new connection.

Reconfig

• The WindoWall Pro sends the output and input numbers response when an input is

switched. Out n is the window number and In nn is the input number.

Out n In nn

Error Responses

When the WindoWall Pro receives a valid SIS command, it executes the command and

sends a response to the host device. If the processor is unable to execute the command

because the command is invalid or contains invalid parameters, it returns an error response

to the host. The error response codes are:

E01 — Invalid input channel number (too large)

E09 — Invalid function number (too large)

E10 — Invalid command

E11 — Invalid preset number

E12 — Invalid output number (applies for addressing windows)

E13 — Invalid value (out of range)

E14 — Invalid for this configuration

E17 — Invalid command for signal type

E24 — Privilege violation

E26 — Maximum number of users connected has been exceeded

E27 — Invalid event number

E28 — Bad filename/File not found

Telnet and Web Communications

The WindoWall Pro can also be controlled via an IP connection using either Telnet (port 23)

or a web browser (port 80). The ASCII and URL commands listed in the tables in this panel

perform the same functions but are encoded differently to accommodate the requirements

of each port (Telnet or browser).

The ASCII to hexadecimal (hex) character conversion table below is for use with the

command and response table (see Command and Response Table for WindoWall Pro

SIS Commands beginning on page 37).

ASCII to Hex Conversion Table

•

Space

Figure 31. ASCII to Hexadecimal Character Conversion Table

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 89 90

Sem comentários

Extron electronics MGP Pro Series Guia do Utilizador Página 37