Extron electronics MGP Pro Series Guia do Utilizador descarregar pdf (Página 30)

WindoWall Pro Series • Remote Configuration and Control 24

If you select the Clear existing I/O ties check box, any connections that you

may have specified previously are removed before the new set of connections is

made. If you do not select the check box, previous connections are retained and

the new connections are added following them (see the example in figure 23).

Figure 23. I/O Schematics Screen with Auto Connected Sources and

Processors

• Manually connect — You can connect the inputs and the processors individually

by dragging icons to the desired locations on the diagrams as follows:

• Drag each source icon (for example, ) to the desired WindoWall Pro

input on the diagram in the center.

• Drag each WindoWall Pro output icon (for example, ) to the

desired location on one of the Processor diagrams at the right edge of the

I/O Schematics screen.

• To delete a tie, do either of the following:

Right-click on the tie to either the matrix switcher diagram or the appropriate

MGP diagram, then click the Delete pop-up button that appears.

Place the mouse over the tie, then press the <Delete> key on your

keyboard.

Figure 24 on the next page shows a schematic diagram being assembled

manually.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 89 90

Sem comentários

Extron electronics MGP Pro Series Guia do Utilizador Página 30