Extron electronics MGP Pro Series Guia do Utilizador descarregar pdf (Página 73)

WindoWall Pro Series • Special Application: Edge Blending 67

Setting up the WindoWall Console Software for Edge Blending

To set up the WindoWall Pro software for a system in which edge blending will be used:

1. Install and open the WindoWall Console software (see Installing and Starting the

Software on page 11).

2. From the Wizards menu on the WindoWall Console main window, select New Project.

3. Follow the instructions on the Setup wizard screens until you reach the Edge

Compensation screen (see Setting up a WindoWall Pro Project on page 15 for

instructions on setting up a project using the wizard).

4. On the Edge Compensation screen, select the Enable Edge Compensation check box

and the Edge Blending - compensate for overlapping projector displays radio

button. The screen changes as shown in figure 45.

Figure 45. Edge Compensation Wizard Screen with Edge Blending Selected

5. In the two incremental spin boxes in the Display Border Size section, enter the number

of overlapping pixels as follows:

• Horizontal pixels overlap — Type or select the number of pixels by which the

images’ right and left borders will overlap each other.

• Vertical pixels overlap — Type or select the number of pixels by which the top

and bottom borders of the image will overlap each other.

6. Click Next to continue, and complete the wizard, following the instructions on the

screens.

7. Use the WindoWall Pro test patterns to help you set up your projectors for the

edge-blended videowall display.

1 2 ... 68 69 70 71 72 73 74 75 76 77 78 ... 89 90

Sem comentários

Extron electronics MGP Pro Series Guia do Utilizador Página 73