Extron-electronics SME 100 User Guide Manual do Utilizador descarregar pdf (Página 32)

Streaming Presets

NOTES:

• For information on recalling and saving streaming presets using the

web-based user interface, see the "Using Streaming Presets" section on page97.

• For information on recalling and saving streaming presets using

SIS commands, see "Streaming presets" on page 140 of the "Command and

Response Table for SIS Commands" section.

• Streaming presets are used in the push conﬁguration only.

Streaming presets are used when a shortcut is needed to quickly recall a group of changes

in the streaming configuration on the SME100.

Streaming Preset Saved Settings

SAP Settings

Stream Method (MPEG-TS) MTU

IP (Multicast or Destination) QoS

Destination Port TTL

The Stream Rcall and Stream Save menus shown in figure 16 on page 23 are used to

recall and save streaming presets. The Stream Save menu creates presets by saving the

current set of streaming parameters for the current output stream. The Stream Rcall menu

recalls and applies a saved preset to the current output stream. Sixteen available streaming

presets are used to recall or save settings.

Input Config Menu

The Input Config menu is used to select and configure a video signal type for the currently

selected input. Figure 17 and the information that follows provide an overview of the

submenus and the options that are available.

PRE

INPUT

CONFIG

INPUT #N

YUVp/YUV–HD

FILM DETECT

IN#N <ON>

H START V

0128 0128

TTLPIX PHASE

0858 016

ACTIVE V

0720 0483

EDID INPUT N

1024x768@60

Film Detect

Tu rn film

detection on

or off for the

selected input.

Input Video Signal Type

Select an available video

signal type. Each input (N)

supports different video

signal types.

Horizontal Start

Select a horizontal

start pixel position

for the left edge of

the active video.

Vertical Start

Select a vertical

start line position

for the top edge of

the active video.

Total Pixels

Specify the width

in pixels of the

total image area

to be sampled.

Pixel Phase

Adjust the pixel

sampling point.

Horizontal Active

Specify the width

in pixels of the

active image area

to be sampled.

Vertical Active

Specify the height

in lines of the

active image area

to be sampled.

Input Resolution

Select the input

resolution. This

menu is used with

inputs (N) 2 and 3.

Refresh Rate

Select the rate:

• 50 Hz

• 60 Hz

Figure 17. Input Config Submenu Overview

SME100 • Front Panel Operation 26

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 184 185

Comentários a estes Manuais

Sem comentários

Extron-electronics SME 100 User Guide Manual do Utilizador Página 32

Comentários a estes Manuais

Manuais e produtos relacionados com Hardware Extron-electronics SME 100 User Guide